Alex has kindly sent me the latest upgrade to his wireless Arduino project.

"The above project is an improvement on the previous one with the same title.

Part I (1st November 2023) used solderless stripboards and jumper leads, and although the receiver had an LED which came on after a successful transmission/reception of a signal, it was not possible at the transmitter end to know whether this had occurred. Part II has overcome this problem by incorporating a flip-flop in the Tx circuit, which parallels the LED at the Rx end.

I hope the photographs are clear."

Regards

Alex Henderson M0TOT

Save
Cookies user preferences
We use cookies to ensure you to get the best experience on our website. If you decline the use of cookies, this website may not function as expected.
Accept all
Decline all
Read more
Session Cookie
A session cookie for a website only exists whilst the user is reading or navigating the website. When the user closes their web browser these cookies are removed.
Joomla Content Management System
Accept
Decline